Is there a way to remarry the fusion drive portion to the SSD/spinning drive image so I can boot again? - is there away to create a boot USB to bring the SSD/Spinning drive into the bootable world and screw the Fusion drive.? Or am I just screwed because I have no time machine backup. Before you begin the process of cloning your Mac hard drive to an SSD, it’s essential to gather the necessary tools and equipment. I have a backup copy of the SSD created from the spinning drive - that has not been on the computer ever. The process of cloning your Mac hard drive to an SSD is a cost-effective and time-saving solution that allows you to enjoy all the advantages of an SSD without the hassle of a clean install. I figure somehow the SSD portion of the Fusion drive is now lost/confused as to what to do. Press any key or wait a few seconds to continue starting up."Īnd it stays in that loop. SO unable to boot from the USB drive - I took the SSD out and put the original spinner Hard drive back - I now get the message "Your computer restarted because of a problem. no go - both drives had the same identifier. I was going to clone the SSD from the 1TB hard drive in the hopes that it would allow me to extend the partition. I was unable to extend the 1TB into the 2TB space available.įollowing CCC advice I put the Hard drive into the USB port and had the SSD inside the imac. I cloned the drive and installed the SSD. Make sure you have both the SSD and the hard drive plugged into your system before initiating the cloning procedure. following bad advice from Carbon Copy Cloner, I managed to break my fusion/Hard drive connection. This too failed to clone in CCC.Ĭomputer: Macbook Pro Non-Retina Mid 2012, I5 processor, 16 Gb ram, 320Gb HDD, Os 10.15 Catalina. I deleted it and erased the drive and formatted APFS in terminal. Before the most recent error in CCC, I was informed by the software that there was a conflict with the destination drive in a folder marked "Resources" which I can only assume is a partitioned section that WD places on their drives, and CCC asked what I wanted to do. I have scanned with DFA and tried multiple times, and getting pretty frustrated. Because I have a simple Sata3 to USB 3 cable connecting them, I am unsure if my connection would be causing this. Admittedly, I haven't done much by way of cleaning up my temporary files, etc on the current booting drive. What appears to be happening is some sort of conflict with the destination drive. I have tried cloning the drive in disk utility, Superduper, and seem to be getting closer to an understanding with a trial of Carbon Copy Cloner. I eventually resorted to erasing the drive in terminal. I have tried a myriad of things to accomplish this task, but I have had lots of issues erasing the drive in disk utility. I have been trying to clone my HDD in a mid-2012 Macbook pro with plans to upgrade to SSD.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |